RIBS

We wanted some metal looking ruins that would look a bit like a rib cage coming up through the ground.
We stared by cutting three curved pieces of wood, of slightly different sizes. We roughly cut out the shapes.

We sanded down the inside of the curves on a circular sander.

And the outside of the curves...

Then we drilled small guide holes about half way through the two outer pieces of wood.

We then drill larger holes over the little ones...

Glued all three together using super glue...

And sprayed it white.

The original plan was to make a cast of this Rib in Gelflex, and then mass produce more in resin. However there were problems making the mould, so instead myself and Rob made another four in the same way as the first one, out of wood...